Gizmodyne | September 21, 2007
Domino
This is only my second project using the domino. This time I set the fence on top of the workpiece instead of setting both on the work surface. I was trying to center the tenon. It worked, but I am not sure if I mastered the technique since some of the parts are not perfectly [...]
Gizmodyne | September 20, 2007
V-grooveI had a break from work yesterday before Back to School Night so I headed out again to finish the beadboard field.
Setting the v-bit
I used a set-up block saved from a prior project to get the v-bit set. The edge groove is simple enough. Just set the bit height to 1/8 and then bury it [...]
Gizmodyne | September 19, 2007
“entry-content” class=”textilized”>
New Joinery Option
In my cabinet project I milled up stacks of tongue and groove beadboard. I never even thought about making it with grooves on both sides and milling splines until I read an article on Finehomebuilding.com (which I highly recommend; get a subscription to their online content).
Cutting only grooves simplifies the joinery and [...]
