Gizmodyne | September 20, 2007
V-grooveI had a break from work yesterday before Back to School Night so I headed out again to finish the beadboard field.
Setting the v-bit
I used a set-up block saved from a prior project to get the v-bit set. The edge groove is simple enough. Just set the bit height to 1/8 and then bury it [...]
Gizmodyne | September 19, 2007
“entry-content” class=”textilized”>
New Joinery Option
In my cabinet project I milled up stacks of tongue and groove beadboard. I never even thought about making it with grooves on both sides and milling splines until I read an article on Finehomebuilding.com (which I highly recommend; get a subscription to their online content).
Cutting only grooves simplifies the joinery and [...]
Gizmodyne | September 18, 2007
Motivation
Wife: Just get out there and start working on it.
Good advice actually. I was dead tired after some yard work, but I went into the shop Sunday afternoon on Kristin’s advice.
Board Selection
I made some changes to the cutlist to reflect a few new measurements. Also I did not have enough wide boards and wanted to [...]
Gizmodyne | September 17, 2007
The Quest
The kitchen is somewhat functional but waiting for its doors and drawers and pullouts. Allright.. it’s not that functional.
Anyway, near the top of the list of 100 thinks to do around the house…. Build custom dishwasher panel.
The dishwasher I bought has a harness. Build a panel. Screw to harness. Attach harness to dishwasher and [...]
