Fixin' Up the Bungalow

The Quest
The kitchen is somewhat functional but waiting for its doors and drawers and pullouts. Allright.. it’s not that functional.

Anyway, near the top of the list of 100 thinks to do around the house…. Build custom dishwasher panel.

The dishwasher I bought has a harness. Build a panel. Screw to harness. Attach harness to dishwasher and voila… Custom panel.

Here is a shot of the waiting bay for the dishwasher.

Murky water
The dishwasher comes with following “relevant” diagrams of panel dimensions.

Design

Something like this anyway. Basic door like my cabinet doors, but taller.

I decided to simplify the beadboard this time by putting slots on both edges and then milling splines to fit rather than tongue and groove. This cuts down the router runs by 2. I am also only v-grooving one face. Cutting down on one more extra set up. (though I have to mill splines.

Planning
I spent some time planning out cutlists and procedures.
Dishpanel Cutlist

Procedure
1. Mill rail, filler and beadbaord stock
2. Beadboard
a. Cut slots ¼ x ½ on router table or table saw.
b. Cut edge “half” v-groove on router table
c. Cut middle v-groove on router table
3. Mill Splines to fit
4. “Domino” beadboard into rails.
5. Sand to 220
6. Glue up
7. Mill filler and baseboard stock
8. Finish
a. 2 coats red mahogany gel stain
b. dewaxed shellac
c. 3 coats wipe on poly

Motivate
I need to get going on this. Since work started again I have been very tired and not super motivated. But the list of 100 things to do must happen. So I am going out this afternoon to look for some stock in the pile.

Wish me luck.

Tags: design, dishwasher panel

This entry was posted by Gizmodyne on Monday, September 17th, 2007 at 10:02 am and is filed under Cabinetry, Kitchen. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.